No, all the section bending machines we produce (with exception for the model of Serie 3000 from 309 up to 315) can be installed both in horizontal and vertical position.

Yes, the CNC of our section bending machines has the possibility to import .dxf files.

No, universal rolls are designed to bend the most common commercial profiles (like flat bars, square bars, angles etc..) but for some profiles (tubes and profiles with particular geometry) special rolls are required.

You can find the proper form in the manual of the section bending machine. If you don’t find it, please send us an email indicating the machine serial number, the spare part code and possibly send us also a picture of the spare required.

We recommend to work respecting the maximum capacity indicated in the capacity chart of the section bending machine and we will not take responsibility of damages caused by improper usage of the machine. Nevertheless is also possible, in some cases, to bend a bit bigger sections, especially if the bending radius is really big.

Yes, it is always possible to bend to bigger diameters than the ones indicated in the capacity chart of the section bending machine

The capacity indicated in the capacity chart of the section bending machine refers to normal steel with yield strength 240 N/mm2

Normally the minimum diameter indicated in the capacity chart of the section bending machine can be achieved in multiple passages.

Some scratches can appear on the surface of the material. In case of sensitive material the usage of special rolls is recommended.

No, on all section bending machines, at both ends of the profile, a certain length remains straight.

We always guarantee the tolerance in the positioning of the movable parts of the section bending machine. We prefer not to refer to the tolerance on the final result because that is strongly affected by the material properties, on which we don’t have a direct control.

Theoretically yes, but for practical reasons the operating range of the section bending machine must not include profiles too small compared to the maximum capacity of the machine.